Guangdong Hongming Intelligent Joint Stock Co.,Ltd

位置:首页 > News > Common

Die-cutting machine which causes pressure decreases

Cutting machine less pressure there are several possible reasons:

     1 belt is too loose. Should be appropriate to tighten, making proper tightness.

     2 clutch friction surfaces incursion into oil or grease. Shall be landed on, gasoline, steel wire brush to clean the friction surface due to wear and slippage, it should be trimmed.

     3 brake gap is too small, often in the braking state. Shall promptly adjust the gap reached :0.8-1 .5 mm.

     4 due to lack of oil, resulting in a burned bearing, axle phenomenon.
      5 Input voltage should be normal, transformers, rectifiers, relays, contactors working properly, the contacts intact without ablation phenomenon, then press each thread should be firm, brush and slip ring good contact, otherwise will cause the cutting pressure decreases .

Hits:  UpdateTime:2013-10-22 14:30:20  【Printing】  【Close
快乐赛车大战破解版 福建11选5开奖 快乐赛车的规律 快乐赛车怎么买才能中 快乐赛车怎么样才能稳赢 快乐飞艇怎么样充值 玖玖棋牌APP下载 快乐赛车彩票靠谱吗 快乐赛车平台官网 快乐赛车计划